Shop / FEYNLAB / The Original Ceramic Coating - Push To Start
FEYNLAB · Protection
The Original Ceramic Coating - Push To Start
- Free click & collect from Nunawading
- Shipped Australia-wide
- Questions? Call 0475 000 066 or email info@shoyi.com.au
The Original Ceramic is FEYNLAB's entry-level nano ceramic coating, packed in a Push To Start box with its own applicator pad. It bonds to paint to leave a slick, glossy, strongly water-repellent finish that sheds dirt and grime. A straightforward wipe-on, wipe-off coating for owners wanting proper ceramic protection without a complicated install.
Key features
- Simple wipe-on, wipe-off application that suits careful DIY owners
- High water contact angle gives strong beading and a self-cleaning effect as water rolls dirt away
- Chemically bonds to paint, helping repel water, oils, fallout, mud and road grime
- Outperforms traditional waxes and sealants for hydrophobic behaviour
- Combines slickness, gloss and durability in one coating
- The most economical coating in the FEYNLAB range
Specifications
| Application temperature |
10°C to 30°C |
| Layers |
1, with optional extra layers on high-wear areas |
| Time between layers |
At least 1 hour, no more than 3 hours |
| Warranty |
1 year |
In the box
- 40ml The Original Ceramic
- Applicator pad
Preparation
- Wash the vehicle thoroughly with Pure Wash or Pure Rinseless.
- Clay and paint correct the surface if necessary.
- Move the vehicle to a well-lit, well-ventilated area between 10°C and 30°C.
Directions
- Shake the bottle vigorously for one minute before coating.
- Apply enough coating to a microfibre sponge applicator to fully cover a single panel, such as a door or half a bonnet.
- Draw a plus sign in the middle of the panel, then a picture frame around the area being coated.
- Fill in the rest of the panel in straight lines from left to right, then cross-hatch up and down to create a level layer with even coverage.
- Let the coating sit until about 75% dry, or until you see rainbows similar to an oil sheen on water.
- Remove the remaining coating with a clean microfibre towel (edgeless recommended). Use a second clean towel to wipe clear if needed; the towel will glide more easily as the product is fully removed.
- Repeat panel by panel, or several panels at a time if conditions allow, until the whole vehicle is coated.
- For extra protection on areas such as leading edges and the bonnet, apply additional layers, waiting at least 1 hour but no more than 3 hours between layers.