Every November the same thing happens in the workshop. The weather turns, the first 35 degree day lands, and owners start noticing what the sun is doing to their car. After 20 years of working on paint in Melbourne, I can tell you summer rarely creates new problems. It exposes the ones that were already quietly building. The good news is that a little understanding now makes the next four months far kinder to your paint.
Clearcoat is a thin, flexible layer, and like most materials it expands and contracts as it heats and cools. A dark bonnet sitting in direct sun can get hot enough that you cannot rest your hand on it. That daily cycle is gentle in autumn and relentless in January. Over years it contributes to the dull, slightly hazy look you see on older cars, especially on horizontal panels like the roof, bonnet and boot.
UV is the other half of the story. It slowly breaks down the clearcoat from the surface, which is why the top of a car ages faster than the doors. Paint that has already been neglected, or has had chips and scratches that let moisture and contamination in, tends to show the damage first.
Heat does not only age paint, it speeds up the damage from whatever is sitting on it. Bird droppings are acidic, and in hot weather they can etch into clearcoat within a day or two. Tree sap, especially under the established street trees in the eastern suburbs, bonds harder the warmer it gets. Insects, road tar and hard water spots all behave the same way. A mark that wipes off in July can leave a permanent outline in January.
The fix is simple and unglamorous. Remove these things early and gently, with plenty of water and lubrication, rather than rubbing them dry. If something has already etched, that is a job for careful paint correction, not a stronger wipe.
Washing a car in direct sun or on hot panels is one of the most common ways owners accidentally mark their paint. Water and shampoo dry before you can rinse them, leaving spots and streaks, and the film of dried product can drag grit across the surface. Wash in the morning or evening, keep panels cool, work from the top down, and use clean mitts and a rinse bucket for the dirty lower sections.
Fine wash marring is cumulative. Each careless wash adds a few hairline scratches, and a dark car in strong sun shows every one of them as swirls. Good habits protect the finish more than any product.
Protection will not make a car immune to summer, but it changes how the paint copes. A quality ceramic coating adds a hard, slick surface that helps contaminants release more easily and makes washing gentler. Paint protection film goes further on the areas that take physical punishment, such as the bonnet edge, mirrors and lower panels, and it also acts as a sacrificial layer against sap and etching on those surfaces.
Neither is a substitute for maintenance, and each suits a different owner and a different car. What matters is that the paint underneath is in good condition when protection goes on, because anything sealed in stays sealed in. That is why preparation, and sometimes correction, comes before everything else in our process.
Before the heat arrives, take ten minutes to look at your car in good light. Check for chips on the bonnet and front bumper, any dull or hazy patches on horizontal panels, residue or sap you have not dealt with, and the condition of any existing coating or film. If water no longer beads or sheets the way it used to, the coating may be tired and worth a look.
Park in shade or under cover when you can, and keep a bottle of water and a clean microfibre in the car for emergencies like bird droppings. These small habits cost almost nothing and prevent most of the damage I see.
I have never believed in scaring owners into anything. Paint is a finish you live with every day, and understanding what is happening to it is the best protection there is. If you would like an honest look at where your car stands before summer, bring it in and we will go over it together, panel by panel, under proper light.
Related services



