Shop / FEYNLAB / Interior Ceramic
FEYNLAB · Protection
Interior Ceramic
- Free click & collect from Nunawading
- Shipped Australia-wide
- Questions? Call 0475 000 066 or email info@shoyi.com.au
Interior Ceramic is a high-solids nano ceramic coating made for cabin surfaces such as vinyl, leather, plastics and trim. It anchors into the material to resist UV, heat, spills and chemicals while making everyday grime easier to wipe away. A natural matte finish keeps the factory look and feel, with no added gloss or greasy residue.
Key features
- Bonds into vinyl, leather, plastics and trim rather than sitting on top like a silicone dressing
- Natural matte finish preserves the original OEM look and texture
- UV resistance helps prevent fading and discolouration
- Handles cabin heat cycling and common interior chemicals
- Reduces surface adhesion so spills and dust wipe away easily
- Levels smoothly without streaking and cures with no tacky or greasy feel
Specifications
| Durability |
6 to 12 months on most interior surfaces (no longevity warranty) |
| Dwell time |
1 to 3 minutes |
| Finish |
Natural matte |
| Solids content |
High solids |
Approved surfaces
- Vinyl
- Leather
- Plastics
- Trim
In the box
- 30ml Interior Ceramic in a metal bottle
Preparation
- Clean all surfaces thoroughly with Interior Cleaner or a suitable IPA wipe-down.
- Panel Prep may also be used to make sure all surfaces are free of oils, residue and contamination.
- Begin coating only once every surface is clean and fully prepared.
Directions
- Shake the bottle vigorously for 2 minutes.
- Open the cap and let the product breathe for 1 minute, then close it and shake for 1 more minute.
- Check that the metal ball bearing inside is fully dislodged and audible while shaking, so the matting agent is fully blended.
- Keep shaking the bottle between each panel throughout the installation.
- Apply enough product to a clean applicator pad to cover the panel being worked on.
- Spread in thin, even, overlapping passes in a crosshatch pattern for full, consistent coverage.
- Allow the product to dwell for 1 to 3 minutes.
- Remove with two clean microfibre towels: the first lifts most of the remaining product, the second follows with a light buff to a clean, even finish. Use minimal pressure throughout.
- Work panel by panel until all interior surfaces are coated.