Shop / FEYNLAB / The Original Ceramic Coating 30ml - Push To Start
FEYNLAB · Protection
The Original Ceramic Coating 30ml - Push To Start
- Free click & collect from Nunawading
- Shipped Australia-wide
- Questions? Call 0475 000 066 or email info@shoyi.com.au
The Original Ceramic is FEYNLAB's most economical and simplest nano ceramic coating, applied with a wipe on, wipe off method and bonding chemically to the paint. It leaves a slick, glossy, strongly water-repellent surface that sheds dirt, oils and road grime, so the car stays cleaner and washes faster. This Push To Start box suits owners and enthusiasts who want to coat their own car.
Key features
- Wipe on, wipe off application that keeps the job simple, one panel at a time.
- Forms a chemical bond with the paint for a lasting protective layer.
- High water contact angle gives strong beading and a self-cleaning effect when rinsed, provided it is maintained as instructed.
- Repels water, oils, fallout, dirt, mud and road grime, so contaminants struggle to bond to the surface.
- Combines slickness, gloss, durability and hydrophobic performance that outperforms traditional waxes and sealants.
- Can be used on most vehicle exterior surfaces.
Specifications
| Application temperature |
10°C to 30°C |
| Finish |
Glossy, slick and hydrophobic |
| Layers |
One layer is sufficient; extra layers optional on high-wear areas |
| Time between layers |
At least 1 hour, no more than 3 hours |
| Warranty |
1 year |
In the box
- 30ml The Original Ceramic
- Applicator pad
Preparation
- Wash the vehicle with Feynlab Pure Wash or Feynlab Pure Rinseless.
- Clay and paint correct the surface if necessary.
- Move the vehicle to a well-lit, well-ventilated area between 10°C and 30°C.
Directions
- Shake the bottle vigorously for one minute before coating.
- Apply enough coating to a microfibre sponge applicator to fully cover a single panel, such as a door or half a bonnet.
- Draw a plus sign in the middle of the panel, then wipe a frame around the area being coated.
- Fill in the rest of the panel with straight left to right lines, then cross-hatch up and down to create a level layer with even coverage.
- Leave the coating on the panel until it is about 75% dry, or until 'rainbows' appear, similar to an oil sheen on water.
- Remove the remaining 25% with a clean microfibre towel (edgeless recommended). Use a second clean towel to wipe clear if needed; the towel will glide more easily as the product is fully removed.
- Repeat panel by panel, or several panels at once if conditions allow, until the whole vehicle is coated.
- One layer is sufficient. Extra layers may be applied to areas needing more protection, such as leading edges and the bonnet.
- When layering, wait at least 1 hour between layers, but no more than 3 hours.