Shop / FEYNLAB / A50 One-Step Heavy Cut Compound
FEYNLAB · Preparation
A50 One-Step Heavy Cut Compound
- Free click & collect from Nunawading
- Shipped Australia-wide
- Questions? Call 0475 000 066 or email info@shoyi.com.au
A50 One-Step Heavy Cut Compound is FEYNLAB's heavy cutting compound for removing swirls, deep defects and sanding marks from even hard clear coats. Its sharp ceramic aluminium oxide abrasives cut quickly yet finish with good clarity, on rotary or dual-action machines. Body shop safe, with no fillers, silicone or waxes.
Key features
- Removes deep defects, including 1000 grit sanding marks
- Hard, sharp ceramic aluminium oxide abrasives give a fast, consistent cut
- Finishes with good clarity, saving time between steps
- Less product needed per job
- Easy to wipe off and use
- Body shop safe, with no fillers, silicone, waxes or conditioners
Specifications
| Abrasive |
Ceramic aluminium oxide |
| Compatible with |
Rotary and dual-action polishers |
| Contains |
No fillers, silicone, waxes or other conditioners |
| Cut |
Removes 1000 grit sanding marks |
| Dual-action speed |
3400 to 4000 OPM |
| Rotary speed |
No more than 1600 RPM |
Approved surfaces
- Automotive clear coat
- Gel-coat surfaces
- Marine painted surfaces
In the box
- 1 bottle A50 One-Step Heavy Cut Compound: 250ml or 1L (size as selected)
Preparation
- Place the vehicle in a well-lit, cool, contamination-free environment.
- Remove excess dirt and contaminants with Pure Wash or Pure Rinseless.
- If necessary, clay the surface to remove bonded contaminants.
Directions
- Rotary polisher: shake the bottle vigorously before use.
- Rotary polisher: prime a wool pad with 4 small coin-sized dots and spread them over the area to be corrected.
- Rotary polisher: start with a section of about 60 x 60cm, reducing the area if heavier correction is needed.
- Rotary polisher: at no more than 1600 RPM, make 2 to 4 slow passes over the section.
- Dual-action polisher: shake the bottle vigorously before use.
- Dual-action polisher: prime a microfibre cutting pad with 4 small coin-sized dots and spread them over the area to be corrected.
- Dual-action polisher: start with a section of about 60 x 60cm, reducing the area if heavier correction is needed.
- Dual-action polisher: at 3400 to 4000 OPM, make 2 to 4 slow passes over the section.
- Either machine: wipe clear with a clean microfibre towel.
- Either machine: check the panel from several angles to make sure no residue is left.
Cautions
- Always wear gloves, an approved face mask and eye protection when using compounds or polishes.
- Do not apply to unapproved surfaces.
From the studio
Shoyi is an authorised FEYNLAB trainer and installer and an official FEYNLAB distributor, so this is the range we use on customer cars in the Nunawading studio, not something we have only read about.
Not sure it suits your car? Call 0475 000 066 or email info@shoyi.com.au and we will point you the right way. Related reading: Why paint prep decides the finish, Paint correction before PPF or ceramic.